1. The cast aluminum heater should first check whether the power supply voltage at the application site is consistent with the additional voltage of the product. If it is different, it should be equipped with the same power supply voltage as the additional voltage of the product.
2. To ensure safety, please remember that the housing of electrical equipment should be firmly grounded.

3. When the cast aluminum heater is repeatedly used for more than three months, it should be energized intermittently under permitted conditions, heated for ten minutes, cut off the power for half an hour, and discharged continuously for three to four times to make it self-driing. Moisture inside the electric heating element.
4. During storage, the cast aluminum heater should be protected from moisture and corrosion, and stored in a well-ventilated place.

How to maintain the cast aluminum heater daily?
1. After the heater has been working for a period of time (according to the user's usage), the incinerator plug should be rotated to remove carbon deposits. If the incineration plug is burned, remove and replace with a new incineration plug.
2. If there is too much carbon deposits, remove the carbon deposits on the inner wall of the water jacket and the incinerator.
3. If it is found that the air intake pipe, exhaust pipe and drip pipe of the main engine are blocked by dirt, they should be cleaned and dredged in time. Please keep the heater room clean and do not place combustible materials around it.





