The anti-corrosion electric heating tube is made of high-quality stainless steel electric heating tube inner core, and the outer Teflon tube is made of strong corrosion resistance. The anti-corrosion electric heating tube is suitable for heating various corrosive liquids. The anti-corrosion electric heating tube adopts a low surface power design to ensure the service life of the product. The installation position of the anti-corrosion electric heating pipe should be taken to prevent solids in the solution from depositing on the surface of the electric heater, or the liquid is too thick or the liquid level is too low, which will burn out the iron fluoride due to poor surface heat dissipation.
The size of the anti-corrosion electric heating tube should not be changed randomly, and the surface area should be small, otherwise the surface power of the electric heater will be too large and affect the service life of the electric heater. The anti-corrosion electric heating tube can be equipped with over-temperature protection or PT-100 temperature sensing probe to ensure product life and equipment safety. The joint adopts fully enclosed anti-acid and alkali, non-heating section and overheating safety protection system is completely customized according to customer needs. The anti-corrosion electric heating tube is suitable for heating various corrosive liquids. The electric heating tube has the advantages of high thermal efficiency, energy saving and electricity saving, and high cost performance, and can be designed in a variety of structural forms.
The anti-corrosion electric heating tube is a new type of strong corrosion-resistant electric heater made of PTFE sleeve, which is used for heating various corrosive liquids. The anti-corrosion electric heating tube has excellent aging resistance and good bending performance, and adopts a low surface load design. There are two types of anti-corrosion electric heating tubes. One is to spray the surface of the heating tube directly with fluorine plastic material, and the other is to cover the outer layer of the iron heating tube and copper heating tube with a fluorine plastic sleeve. The anti-corrosion electric heating tube of the electroplating cleaning tank is more suitable for heating places with anti-fouling, and is the choice for anti-rust and anti-fouling. At the same time, it can reduce acid consumption, energy consumption, waste liquid generation and improve the working environment, which is beneficial to environmental protection. The use temperature of the anti-corrosion electric heating tube of the electroplating cleaning tank is below 110°C.
