Mechanical banding machine normal problems and solution

- Mar 12, 2020-

Mechanical banding machine is generally used for kitchen, wooden goods of side curve and straight edge banding. When it is used for a long time, there will be some problems that happened. Following are some problems and solutions we can do,


1.The machine itself failure: mainly manifested in transmission failure, cutter failure and so on. In such a case, we should immediately cut off the power to check whether each part of the machine is firm and intact, and tighten it if it is loose.



2. Unable to feed: The cause of the failure should be the damage of the pneumatic components, and it should be checked in time or called for professional maintenance.


3. The main engine stops: If you find these problems, you should immediately find a professional people to inspect the motor, heating element, and electrical heating control box. If you can't handle it in time, it is likely to cause damage to the heating tube element and motor.


4. The viscose is misaligned or sticky: This is related to the edge band, sol quality, rubber wheel, etc. If such a failure occurs, it should be checked whether the sol is made of a high-quality sol, and the relevant technology should be notified in time to handle it.


5. Chain failure: Neither the conveying chain nor the conveying chain can be tightened or loosened too much.