How to Replace Electric Kettle Heating Plate?
The heating wire of the electric kettle heating plate is covered by aluminum and cannot be replaced if it is broken.
1.If the electric kettle does not heat water, it is assumed that it is due to a thermostat problem, just find the same product and replace it. If the electric kettle is to boil the water, the temperature control switch does not trip, you can know the problem of the temperature control switch, then you only need to replace the temperature control switch to solve the problem.

2. Assuming that the electric kettle heating plate does not heat, this shortcoming requires consideration of what material the electric kettle is made of. If it is a plastic kettle, generally you can directly replace the heating plate. It is a stainless steel kettle. It is estimated that the entire steel pot body of the electric kettle is To be scrapped.
3. There is another situation that the electric kettle does not heat up. The indicator light is on and does not heat up. In this case, there may be a problem with the kettle design. Check to see if the thermostat is turned on and not reset. It may also be a problem with the heating plate. For example, The heating plate is damaged, the temperature controller or the temperature fuse is damaged, or the internal circuit of the heating plate is damaged, it may also cause the heating plate to not be energized.

4. Assuming that the indicator light of the electric water heater is on and not heating
a. When the indicator light is on, find out that the power cord is good.
b. The metal sheet in the base of the electric kettle is in poor contact with the electric heater.
c. The electric heater is damaged, which is usually caused by poor internal contact.
The specific operations are as follows:
Tear off the sticker on the outside of the indicator light to expose the screws, use a screwdriver to remove it, you can open the base panel, then unscrew the three fixing screws inside the base, and remove the small screw in the center of the base. Next, you can see the contact surface between the metal sheet and the electric heater. Generally, the poor contact metal sheet will change color. If it is normal, you can use a multimeter to measure whether the electric heater is outstanding. If it is damaged, you can buy a set from the electrical market and reinstall it .





