How to install silicone rubber heater:
Method 1: You can hold a small area of thermally conductive silicone sheet with one hand and tear off one of the release paper protective films with the other hand. But remember, you can't tear off both protective films at the same time to reduce the number and area of direct contact with the thermally conductive silicone sheet. In this way, the self-adhesion of the thermally conductive silicone sheet can be kept from being damaged. Keep your hands in direct contact with the thermal conductive silicone sheet as little as possible to avoid the influence of dirt. Of course, for a large-area thermally conductive silicone sheet, two people must work together to complete it.
Method 2: After tearing off one side of the release film, the torn side faces the radiator, align the thermally conductive silicone sheet to the position of the radiator, and fit seamlessly between the interfaces. One thing to note is to put it down slowly, so as to avoid the formation of air bubbles. If bubbles are formed after the operation, you can gently tear up a corner, pull it up, and put it down slowly. You can also use a tool to gently iron the thermally conductive silicone sheet to remove air bubbles. The force should not be too large to prevent the thermally conductive silicone sheet from being damaged.





