How to correctly install the quartz infrared heating lamp to extend the life?
1. Lamp installation
A.For vacuum-sealed short-wave heating tubes and carbon fiber medium-wave heating tubes, please avoid fixing the mounting bracket on the pressure-sealed part and the insulating ceramic head when the lamp is installed and fixed. Because this part is sintered at high temperature and then squashed, the stress in this part is high and very fragile; in addition, the lamp mounting bracket should not be fixed too tightly.
B. For the non-vacuum double-hole mid-wave infrared heating tube, a mounting bracket with a baffle is required. Because the mid-wave tube is non-vacuum, the filament in the tube can be moved. When the power is on, the thermal expansion of the filament will extend and block The board can prevent the extension of the filament and ensure the normal use of the lamp.
For lamps with a total length of more than 2 meters, we recommend three lamp installation fixing points, that is, in addition to the two ends, a support point is also required in the middle of the lamp.
2. Installation of water cooling device and air cooling device
The main purpose is to cool the lamp tube and prolong the service life of the lamp tube; especially for the gold-plated lamp tube, it can effectively guarantee the use time of the gold-plated coating and play the best role of the gold-plated coating; in addition, air cooling can be indirect The average furnace temperature.
3. Reflector
To heat irregular objects, an adjustable angle reflector should be used. Through the movable device at one end, the entire reflector (lamp tube) can be adjusted in a 180 degree plane to find the heated object, which can absorb infrared maximum The best location for radiation. (The main material of the reflector is aluminum, some parts are stainless steel, and the longest can be 2 meters).
In addition to adjusting the radiation angle, the reflector can also be used for lamp installation, reflection, and focusing of the light source on the object to be heated.
4. Clean up dirt regularly
If the surface of the quartz tube of the radiation light source is stained, please wear soft and clean sandy gloves when the lamp is not working, and wipe it with a sponge moistened with alcohol. This can improve the working efficiency of the lamp. Reduce the temperature inside the quartz tube to ensure the service life of the lamp. (If the light source cannot be radiated normally, and the heat accumulates in the quartz tube, the temperature inside the tube will be too high and the quartz tube will be damaged).
