The cartridge heater for mold heating made by Jaye industry has the advantages of small size, high thermal efficiency, low cost, fast temperature rise, easy installation, safety and reliability, and long life. When using it, it should be attached to the mold as much as possible, so that heat can be transferred to the mold more quickly. The gap is normally about 0.05mm-0.1mm, such as the diameter of the mold hole: Φ12mm, the diameter of the pipe Φ11.8-Φ11.9mm is more suitable.
Specifications of the cartridge heater for mold heating
Surface load: ordinary: 1-4w/cm2, imitation imports: 6-8w/cm2, imports:1-22w/cm2.
Outgoing wire: there are two type of lead wire can be choose: inner lead and outer lead wire.
Tube material: stainless steel 304, stainless steel 316, stainless steel 321, incoloy and titanium tube can be choose by customer..
Voltage: 12-660V, make based on customer’s requirements
Tube diameter: φ3-φ30mm, single tube length: 15mm-6000mm.
Other Applications of the cartridge heater for mold heating
Small mold heating has been accepted by a wide range of customers in modern industrial applications.
Heating- casting, mould head, die punching.
Used in plastic and rubber mechanical heating system, such as: flat vulcanizing machine, extrusion container.
Food and pharmaceutical production lines and health field.
Laboratory heat treatment test.
Petroleum, cable and chemical industries.